Raptorfire Xbox 360 Flexboard with Illuminating Thumbsticks for Xbox 360 Controllers
We will beat any official distributors price
ONLY BUY YOUR RAPTORFIRE CHIPS FROM CERTIFIED DISTRIBUTORS - DONT RISK BUYING CLONES OR CHEAP RIP OFFS
The guys at Raptorfire have put together one of the most extensive and revolutionary mods on the market with the Raptorfire for Xbox 360. Now you can get yours to install in your very own Xbox 360 controller.
PLEASE READ THE FOLLOWING:
Only works on CG1 and CG2 Type Controllers
- 1. Once your controller is back together you will put your batteries in and
turn on your controller.
- 2. You will see Red light on position 2, Red light in position 3 and Green
Light in position 4.
- 3. The light in position 2 will let you know what option you are adding or
- 4. The lights in position 3 ( Red ) and position 4 ( Green ) tell you Green
(YES) or Red (No)
- 5. You will press either your Red (B) or Green (A) to say yes or no. (do you
want this option)
Options Listed Below :
- Red= Drop Shot
- Yellow= Jitter
- White= Active Reload
- Blue= Fast Reload
- Purple= Sniper Hold Breath
- Green= Burst
When you are programing if you get to the Green and think you might have made
a mistake you need to stop and take your battery out and start your programming
all over. If you go through all 6 options and answer them you will lock the
controller permanently. If you think you might have made a mistake and you have
not gone through all 6 options then you can just remove the batteries and it
will allow you to start over.
DISCLAIMER: Some level of installation knowledge is required to properly
install the chip. If you do not properly install it, you could possibly damage
your controller and your Raptorfire Chip. Please note we are NOT responsible for any damage to the
controller or the Raptorfire Chip (Flexboard) as a result of improper installation.
When you install the chip and power on the controller for the FIRST TIME, all of
the LEDs will light up. BEFORE PRESSING ANY OTHER BUTTONS, you MUST press the
"A" (green) button continuously until only the player 1 LED is on. If you do not
complete this step your controller will not program correctly and it will damage
the mod. If you fail to follow this step, we will not be responsible for your
controller or the chip.
VERY IMPORTANT REGARDING CONTROLLER
TYPE FOR MOD INSTALL
- PLEASE READ
The RaptorFire mod chip is only compatible with CG1 and CG2 type controller
boards. It is NOT compatible with Matrix type boards. In order to verify if your
controller is CG1/CG2/Matrix, remove the battery pack and look at the left-most
section of board that is visible thru the controller shell. If your controller
is CG1 or CG2 you will see a capacitor that looks like one of these:
one of these capacitors is present then your controller is compatible with the
RaptorFire mod chip. If neither of these capacitors is visible on the left side
of the board under the battery pack then your controller is a Matrix board and
is therefore NOT compatible with the RaptorFire mod chip. Please verify this
prior to placing your order. THIS IS EXTREMELY IMPORTANT.